|
RE-TAP-ER
SECOND OPERATION MACHINE |
|
THE
FASTEST AND EASIEST WAY TO:
•
Retap threaded parts
• Chase threads
• Remove cutoff burrs from threads
• Inspect threads (with thread gage mounted in chuck)
• Countersink holes
• Deburr holes
• Ream holes
|
1/2"
capacity chuck
*1/3
H.P., 115V, Single Phase
1725
RPM, A48 Frame Motor
Weight
27 lbs
|
|
The
Re-TAP-er has a double disc friction drive that reverses rotation
instantly by the application of forward or backward hand pressure
on the part being retapped.
The
friction discs are driven by a Rubber Drive Ring mounted on the
motor shaft. |
|
|
*Can
be supplied without motor or with special
motors for countries where this is
not suitable. Prices on application.
|
|
CAT.
NO.
|
RE-TAP-ER
|
|
BB-7
|
DRIVE
RING
BLACK
NEOPRENE
|
|
BB-7HD
|
HEAVY
DUTY DRIVE RING
ORANGE
URETHANE
|
|
BB-21
|
PKG.
OF 6 FINGER
PROTECTORS
|
BB-7 RING
INSTALLED BB-7HD RING INCLUDED
NEW
IMPROVED DESIGN
-
Motor
slides back for easy drive ring replacement
-
Pilot
light switch warns if motor left running
-
Solid
one piece enclosed housing
-
Rugged
construction yet light weight and portable (only 27 lbs)
 
Maximum
spindle speed of the RE-TAP-ER is approximately 1,000 R.P.M. and 300 R.P.M.
for the STC-TAP-ER.
However,
because the unit is driven merely by friction, it would be impossible to
guarantee any particular R.P.M., since the R.P.M. will vary with the
pressure exerted and the operation performed.
|
|
WARNING!!
TO AVOID INJURIES, WORK PIECE SHOULD BE HELD IN AN
APPROPRIATE CLAMPING DEVICE WHILE BEING TAPPED AND SHOULD NEVER BE
HELD BY HAND WITHOUT ADEQUATE PROTECTION. |
|
|
STC-TAP-ER
TAPPING MACHINE |
|
|
HEAVY
DUTY TAPERED CONE DRIVE
TAPS
UP TO 5/16-18 THREAD IN 1/2" STEEL!!
|
1/2"
capacity chuck
*1/3
H.P., 115V, Single Phase
1725
RPM, A48 Frame Motor
Weight
27 lbs
|
|
The STC-TAP-ER has a double disc friction
drive that reverses rotation instantly by the application of forward or
backward hand pressure on the part being tapped.
The friction discs are driven by a Heavy
Duty Tapered Cone Drive Collar mounted on the motor shaft.
|
|
CAT.
NO.
|
STC-TAP-ER
PARTS
|
|
BB-TAP-4
|
FRICTION
DISC ASSEMBLY
|
|
BB-TAP-6
|
SPINDLE
CONE ASSEMBLY
|
|
FEATURES
•
Push to tap in
• Pull to tap out
• Sliding face plate
• Work table can be reversed when not needed
• Adjustable "V" plate for small parts (removable)
• Easy to set stop for tap depth control
• Comfortable bench height working area
• Long lasting tapered cone drive
• Pilot light switch warns if motor left running
|
|
*Can
be supplied without motor or with special
motors for countries where this is
not suitable. Prices on application.
|
