View Cart
(203) 753-2114 
(203) 756-5489
Davenport Kwik-Form Toolbit Holder
FOR FAST SET UPS ON SHORT RUNS
No need for special tools -- simply hand surface grind form into standard H.S.S. or Carbide tool bit; or even circular grind, using Kwik-Form as a fixture. Kwik-form mounts right onto the tool post like a form tool. Fits front or rear slides for forward or reverse rotation. With Somma's new Kwik-Form holder, it's no longer necessary to remove the circular form tool post when using tool bits on short runs. Special length tool bits are available from stock as shown at right.
Note: Workpiece diameter differences will vary as tool is resharpened if form toolbit is not circular ground.
WIDER BITS MAY BE USED BY ALLOWING OVERHANG.
No need for special tools -- simply hand surface grind form into standard H.S.S. or Carbide tool bit; or even circular grind, using Kwik-Form as a fixture. Kwik-form mounts right onto the tool post like a form tool. Fits front or rear slides for forward or reverse rotation. With Somma's new Kwik-Form holder, it's no longer necessary to remove the circular form tool post when using tool bits on short runs. Special length tool bits are available from stock as shown at right.
Note: Workpiece diameter differences will vary as tool is resharpened if form toolbit is not circular ground.
|
MACHINE |
CENTER |
TOOL BIT |
CATALOG |
|
DAVENPORT |
9/16 REAM |
3/8 SQ. |
Kwik-Form Tool Parts
|
Part. No. |
ITEM |
|
Clamp Screw DAV |
|
|
H.S. 3/8 Sq. x 2" Tool Bit for #0 & DAV |
WIDER BITS MAY BE USED BY ALLOWING OVERHANG.