Endmills, Long Length, Solid Carbide





Uncoated* Single End Square with 2 or 4 Flutes
* For coating options, see listings at the bottom of this page

Diameter Flute Length Overall Length Uncoated Part#
2-Flute
Uncoated Part#
4-Flute
1/8" 1" 3" EMLC2-1/8 EMLC4-1/8
3/16" 1-1/8" 3" EMLC2-3/16 EMLC4-3/16
1/4" 1-1/2" 4" EMLC2-1/4 EMLC4-1/4
1/4" 1-1/2" 6" EMLC2-1/4-6L EMLC4-1/4-6L
5/16" 1-5/8" 4" EMLC2-5/16 EMLC4-5/16
5/16" 1-3/4" 6" EMLC2-5/16-6L EMLC4-5/16-6L
3/8" 1-3/4" 4" EMLC2-3/8 EMLC4-3/8
3/8" 3" 6" EMLC2-3/8-6L EMLC4-3/8-6L
1/2" 1-1/2" 6" EMLC2-1/2 EMLC4-1/2
1/2" 3" 6" EMLC2/3-1/2 EMLC4/3-1/2
5/8" 3" 6" EMLC2-5/8 EMLC4-5/8
3/4" 3" 6" EMCL2-3/4 EMCL4-3/4
3/4" 4" 7" EMCL2-3/4-7L EMCL4-3/4-7L
1" 3" 6" EMCL2-1 EMCL4-1
1" 4" 7" EMCL2-1-7L EMCL4-1-7L


* For coated endmills, add the appropriate designation shown below to the end of the part numbers listed above;

-TIN A general purpose coating offering wear resistance and reduced friction. Can provide up to 4 times the tool life at 2 times the machining rate vs uncoated.

-TICN High abrasion resistance, lower friction and 80% harder than TIN coating but with a lower temperature threshold. Can provide 2 to 4 times the tool life over TIN.

-ALTIN Has the highest temperature resistance while maintaining a high degree of surface hardness. Best choice for dry machining. A good choice for titanium & stainless alloys, inconel, and cast iron.