Endmills, Stub Length, Solid Carbide


Endmills, Stub Length, Solid Carbide


Uncoated* Single End Square with 2, 3 or 4 Flutes
* For coating options, see listings at the bottom of this page

Diameter Flute Length Overall Length Uncoated Part#
2-Flute
Uncoated Part#
3-Flute
Uncoated Part#
4-Flute
1/32" 1/16" 1-1/2"   EMSC2-1/32   EMSC3-1/32   EMSC4-1/32
3/64" 3/32" 1-1/2"   EMSC2-3/64   EMSC3-3/64   EMSC4-3/64
1/16" 1/8" 1-1/2"   EMSC2-1/16   EMSC3-1/16   EMSC4-1/16
3/32" 3/16" 1-1/2"   EMSC2-3/32   EMSC3-3/32   EMSC4-3/32
1/8" 1/4" 1-1/2"   EMSC2-1/8   EMSC3-1/8   EMSC4-1/8
5/32" 5/16" 2"   EMSC2-5/32   EMSC3-5/32   EMSC4-5/32
3/16" 3/8" 2"   EMSC2-3/16   EMSC3-3/16   EMSC4-3/16
7/32" 7/16" 2"   EMSC2-7/32   EMSC3-7/32   EMSC4-7/32
1/4" 1/2" 2"   EMSC2-1/4   EMSC3-1/4   EMSC4-1/4
5/16" 1/2" 2"   EMSC2-5/16   EMSC3-5/16   EMSC4-5/16
3/8" 5/8" 2"   EMSC2-3/8   EMSC3-3/8   EMSC4-3/8
7/16" 5/8" 2-1/2"   EMSC2-7/16   EMSC3-7/16   EMSC4-7/16
1/2" 5/8" 2-1/2"   EMSC2-1/2   EMSC3-1/2   EMSC4-1/2
5/8" 3/4" 3"   EMSC2-5/8   EMSC3-5/8   EMSC4-5/8
3/4" 1" 3"   EMSC2-3/4   EMSC3-3/4   EMSC4-3/4
1" 1" 3"   EMSC2-1   EMSC3-1   EMSC4-1

* For coated endmills, add the appropriate designation shown below to the end of the part numbers listed above;

-TIN A general purpose coating offering wear resistance and reduced friction. Can provide up to 4 times the tool life at 2 times the machining rate vs uncoated.

-TICN High abrasion resistance, lower friction and 80% harder than TIN coating but with a lower temperature threshold. Can provide 2 to 4 times the tool life over TIN.

-ALTIN Has the highest temperature resistance while maintaining a high degree of surface hardness. Best choice for dry machining. A good choice for titanium & stainless alloys, inconel, and cast iron.