IS-62

Shave Tool Holders


INSTRUCTIONS FOR RQCDAV-C

RESHARPENABLE QUICK CHANGE INSERT SHAVE TOOLS

FOR CIRCULAR POSITIONS OF DAVENPORT MACHINES   

 

      IMPORTANT!!!!  THIS TOOL WILL NOT PERFORM SATISFACTORILY UNLESS THESE INSTRUCTIONS ARE FOLLOWED EXACTLY!!! 

 

1.  INSERT STEPS MUST BE  CALCULATED BASED ON .875” HEIGHT AT .000 BASE PART DIAMETER.    EXAMPLE: TO SHAVE A .200” DIA -  STEP DIFFERENTIAL SHOULD BE ,100” INSERT HEIGHT SHOULD BE .775”.  (SEE SAMPLE INSERT DESIGN ENCLOSED.)

 

2.  SET SPACE BETWEEN ROLL AND INSERT WITH A BLOCK GAGE.  GAGE  SHOULD BE PLACED BETWEEN THE ROLL AND THE STEP ON THE INSERT THAT FORMS THE DIAMETER BEING ROLLED ON.

 

3.  CHECK THAT DOVETAIL SLIDE (PT NO. 37 ) PROTRUDES BELOW BODY OF TOOL (PT NO. 1) APPROXIMATELY 1/32”.- IF NECESSARY ADJUST WITH SCREWS (PT NO.13 AND 14 ).

***TOOL WILL NOT PERFORM PROPERLY IF THIS SETTING IS NOT MAINTAINED******

 

4.  REMOVE INSERT FROM TOOL --  MOUNT TOOL ON MACHINE AS YOU WOULD A CIRCULAR TOOL AND ROTATE UNTIL ROLL IS SET SO THAT TOOL RAISES APPROXIMATELY 1/32” WHEN IT CONTACTS THE DIAMETER IT IS TO ROLL ON.

      

5.  MOUNT INSERT BACK INTO HOLDER AND MAKE A TEST CUT.  FINE TUNING OF  PART DIAMETERS CAN BE MADE BY ADJUSTING THE ROLL SLIDE WITH SCREW (PT NO. 15).

 

6.  PART TAPERS CAN BE CORRECTED BY ADJUSTING TWO SCREWS (PT N0. 6) ON BACK OF BODY.

 

7.  ALL OTHER INSTRUCTIONS ARE SAME AS RQC SHANK TYPE SHAVE TOOLS INSTRUCTION SHEET ATTACHED.